Saturday 11 August 2012

Voile seams

After sewing my side seams in the voile I had to remove the thread tracing. It shows here why its nice to do the thread ends away from the seam well into the seam allowance -  You can just snip close to the knotting and know that it will be cut away when it comes to hot knife cutting the seam allowance.


Heres a close up of the finished seams (before ironing) - no knots, no fraying.

Here are the panels attached to the dressmaker and pinned roughly in place. I pinned all the lace bits and bobs on to check the dress still looks like I imagined - I'm still feeling confident!



And the back...



Friday 10 August 2012

Cutting seams with a hot knife or soldering iron

Today started with a sample - I tried out all the tensions (I settled on '1'), and whether to use cream thread, white thread, or a mix of cream and white. I settled on cream. I also tested whether to sew the seam once it was trimmed and ironed and decided it didn't need it.

For the seams of the voile I decided to make the most of the synthetic fabric and heat cut after sewing - this heat seals the edges. Heres my set up - a marble cutting board (glass is usually recommended), a metal ruler, the soldering iron with a pointed tip, a water soaked sponge and some more cleaning items (a sanding block, emery board and nail cuticle remover which can get rid of the worst bits).


Get your fabric and ruler ready..

Line up the seam so that its straight..

Then move the ruler up to give a seam allowance.

Hold down, be careful to keep your fingers away from the blade!

Then smoothly cut (I had to remove my fingers as I was taking this picture)!

 Peel away the excess whilst still holding the ruler. It might be worth cutting away the excess as you go rather than keeping one big strip - especially with hot knifes around!

Unfortunately the tip becomes pretty grubby - if its not cleaned regularly this transfers to the fabric.

To clean keep a soaked sponge nearby and clean as you go - use the wet part of the sponge. Just to let you know the sponge WILL be ruined so perhaps keep one set by just for this.

Even with the sponge there may still be some residue...

So use fine sandpaper to clean this off. Use brisk movements as the sandpaper will burn too!

An emery board is also useful.

Heres the completed cut seam. 

So I've sewn all the seams in the voile fabric. NB apart from one seam at each side, like the other skirt layers - the skirt layers are now in two sections 'front' and 'back'.

I have a few more pics but I'll save them for tomorrow as this post was more of a tutorial!

Friday 3 August 2012

Bridesmaids' fur shrugs completed!

All cut out, darts sewn, and ready to go...


Simply sewn around the edges, leaving a gap at the bottom. Then Notches and slits so that the curves will work properly once turned right way out.


All four turned the right way out - I only need three for the bridesmaids so I'm going to try to sell one! Last thing to do was to hand sew the small hole left from turning closed.


They all look the same so here are some completed shots.